The issue seems to be with high gain situations.Īny ideas? Sorry for the novel, it's been two weeks of trying to figure the problem out. The first method i can think of is to go from my pedals into my amp and then use the fx loop from the amp and a reamp box to. Now instead of amp modelling i want to use a real guitar amp. I've tested the issue with a Fender tube combo, which has noise, but much less. so my guitar setup at the moment uses overdrive pedals for my gain sound and uses ableton for my post gain stuff like delays. It's still there, but dramatically quieter. Just today I bought a Behringer MicroHD HD400 hum eliminator, which did dramatically attenuate the noise. Additionally, I thought the issue was with the specific Eleven rack I owned, so I exchanged it. This active DI is ideal for Reamping as it will not load down the pickups and will deliver the true sound of the instrument without. Start by recording with the industry standard Radial J48 direct box. I've tested the set up on various outlets throughout the building I work, on various circuits. Reamp kit contains Radial J48 DI and X-Amp Reamper in carry case The Radial Reamp Kit includes everything you need to Reamp in a single case. I have both devices plugged into a Furman power conditioner, and have tested with a Livewire power conditioner as well. The moment I bring gain into the picture, noise is introduced. If I crank the overdrive volume all the way, but keep the gain at zero, no noise. If I set the Marshall to its clean channel and crank the volume to max, no noise. Continue with the installation of the potentiometer and the 1/4 plug and tighten with a wrench to secure them into the unit. Install the toggle switch and use a wrench to firmly tighten the nut. ![]() If I turn down the output levels on the Eleven Rack down to a Mute status, the noise does not turn down. To build a DIY reamp box, start with the XLR jack. No computer, guitar, or even audio being played necessary. ![]() To recreate the issue, I only need to plug my Eleven Rack into the amp, via the Output to Amp into the amp's Input. Radial Reamp JCR 1-ch Passive John Cuniberti Reamper w/ Level Control & Filter 219.99. Upon further research, I've plugged my Eleven Rack into a Marshall solid state practice amp and recreated the same issue. When I attempted to use the reamp feature with a Laney guitar head and 2x12 cabinet, a tremendous amount of broadband white noise came through, rendering the reamping unusable. ![]() I'm trying to reamp DI guitar tracks through an amp with it, using the Output to Amp outputs (either 1 or 2). However, I have an issue I can't seem to resolve involving the Eleven Rack. I apologize in advance if my post is not in the correct forum.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |